I am using a Sonicwall NSA2600 as my firewall/ router.How can I get each C. I need to configure a VPN on each Cradlepoint to connect back to the network at the office. I am getting ready to deploy 20 Cradlepoint IBR-900 routers in police patrol vehicles. Cradlepoint Routers to Sonicwall VPN Security.You can skip all those steps, format FAT32 and drag the contents of the ISO to the root of the key :) Use the 'format fs=fat32 quick' command to format it as FAT32, using the Quick (fast) routine.Use the 'assign' command to assign a drive letter to the USB drive - it will show up as a drive under My Computer.Ĭopy the extracted contents of the Windows 10 ISO to the USB driveĬopy the extracted contents of the Windows 10 ISO to the USB driveprobably didn't work for you as I'm guessing your key was already formatted NTFS. Use the 'select partition 1' command to select that partition.Use the 'active' command to make said partition active. Use the 'create partition primary' command to create a primary partition on the USB drive.

Use the 'select disk X' command to select the USB drive - 'X' is the disk number of your USB drive, and it is shown in the first column.Use the 'clean' command to erase everything on the USB drive. Use the 'list disk' command to display the list of storage drives - it will reveal all the HDDs, SSDs, USB drives, and so on, that are attached to your PC.Identify the disk number of the USB drive that you are using - you can easily find it by looking at the size column it is usually the last one that is listed. Accept the UAC prompt, if asked, to continue. Use the 'diskpart' command to open the disk partitioning software. To do this, open Run (Windows key + R will do the trick alternatively, it can be found in the Start menu), type 'cmd' and then press the OK button. Plug in the USB drive and follow the next steps to create the installation media:

I don't think just copying the contents of the ISO to a USB drive will work.

Install win 10 from usb